GovWire

AAIB Report: BAe ATP (SE-LPS), Autopilot failed to disengage prior to landing, Ronaldsway Airport, Isle of Man.

Air Accidents Investigation Branch

August 25
10:05 2022

During a flight to Ronaldsway Airport on the Isle of Man, as the aircraft approached the minimum descent altitude, the autopilot would not disengage. There was no audio tone to indicate the disengagement and the co-pilot (pilot flying) felt there was resistance in the flying controls. Despite this, the cockpit indications showed that the autopilot had disengaged. Subsequently the synchronisation (SYN) button was pressed, which released the controls and the flight landed safely. Both pilots were unharmed.

A definite cause for the autopilot not disengaging could not be found but the manufacturer responsible for the design of the autopilot identified a possible scenario where the autopilot servomotors could remain engaged after the autopilot disengaged. This would result in higher-than-normal forces at the cockpit controls. Audio anomalies during the flight were probably caused by corrosion in the audio warning unit because of moisture ingress through the DV windows.

As a result of this investigation safety action was taken by the CAA to consider additional testing of the autopilot system as part of the continued airworthiness programme for the ATP. The operator took safety action to reconfigure their fleet so that either pilot could override either autopilot via the SYN button on their respective control wheel. The operator also initiated remedial action to try and prevent water ingress into the cockpit.

In addition, two Safety Recommendations have been made to the CAA regarding the use of magnetic tape recorders.

Read the report.

Media enquiries call:

Related Articles

Comments

  1. We don't have any comments for this article yet. Why not join in and start a discussion.

Write a Comment

Your name:
Your email:
Comments:

Post my comment

Recent Comments

Follow Us on Twitter

Share This


Enjoyed this? Why not share it with others if you've found it useful by using one of the tools below: